f Fuji PLC power supply module- A&S Automation Co., Ltd
 
Home / PLC / Fuji PLC / MICREX SX SPH Series / Fuji PLC power supply module

Add To Cart
share
Redundant power supply module(NP1S-22/NP1S-42) Redundancy of the powersupply has been realized by supplying the power from multiple (up to 3) powersupply modules. The redundant configuration of the power supply section withthe highest failure rate can improve the system reliability. Small capacity power supply module(NP1S-81/NP1S-91) The use of the 100V AC or200V AC small capacity power supply module (single slot) on the 3-slot and6-slot basis allows effective use of one slot. Item Specification Type NP1S-22? NP1S-42 NP1S-81? NP1S-91? Rated input voltage 100 to 120V AC / 200 to 240V AC 24V DC 200 to 240V AC 100 to 120V AC Voltage tolerance 85 to 132V AC / 170 to 264V AC 19.2 to 30V DC 170 to 264V AC 85 to 132V AC Rated frequency 50/60Hz - 50/60Hz Dropout tolerance 1 cycle or less(Rated voltage, rated load) 10ms or less(Rated voltage, rated load) 1 cycle or less(Rated voltage, rated load) AC waveform distortion factor 5% or less - 5% or less Ripple factor tolerance - Three-phase full-wave rectification can be used 5% or less - Leakage current 0.25mA or less Inrush current 22.5Ao-p or less (Ta=25C not repeated) 150Ao-p or less 2ms or less 22.5Ao-p or less (Ta=25C not repeated) Power consumption 110VA or less 45W or less 50VA or less 40VA or less Rated output voltage 24V DC (22.8 to 26.4V DC) Output current 0 to 1.46A 0 to 0.625A Isolation method Transducer Dielectric strength 2300Vrms AC, 1 second, between power input terminals and ground 510Vrms AC, 1 second, between power input terminals and ground 2300Vrms AC, 1 second, between power input terminals and ground 1400Vrms AC, 1 second, between power input terminals and ground Insulation resistance 10M? or more (500V DC megger) No. of occupied slots 2 slots 1 slots (specialized for the 3-slot and 6-slot basis) Alarm output Relay NC contact output(Monitoring of output voltage: 24V DC, 0.3A or less) None Multiple power supply Compatible(Up to 3 units mountable on the base board.) None Mass Approx. 360g Approx. 180g ?)Note that UL-certi?ed models are di?erent as shown below (the products are the same) Standard model UL-certi?ed model NP1S-22 NP1S-22 A NP1S-81 NP1S-81 A NP1S-91  

Hot Products
Reviews(0)
Write a Review

Level:
 
Name:  
Reviews: